Radar‐based structural health monitoring of wind turbine blades: The case of damage localization

This short communication reports on a radar approach for structural health monitoring of wind turbine blades. Therefore, a bistatic frequency‐modulated continuous wave (FMCW) radar in the frequency range from 33.4 to 36.0 GHz has been developed and tested experimentally using a laboratory wind turbine demonstrator. A differential damage localization framework is presented here that exploits signal differences between measurements from the intact and the damaged structure for 3D imaging of the defect. We have achieved the localization of a 30‐mm cut in a glass fiber composite structure as well as the localization of a water pack at the backside of the specimen with a localization error of several centimeters.     

Numerical Study of Three Different Approaches to Simulate Nanofluids Flow and Heat Transfer in a Microtube

In this paper, Eulerian, mixture and single phase models are used to simulate laminar and turbulent forced convective flow of SiO₂‐EG nanofluid in a microtube. The comparison between the three approaches and other formula shows that for laminar and turbulent flow the single phase model shows higher heat transfer enhancement and is more precise in comparison to the other Eulerian and mixture models.      

40 Gb/s 4-QAM OFDM radio over fiber system at 60 GHz employing coherent detection

In this paper, the simulation of 60 GHz millimeter-wave radio over fiber link with 4-QAM OFDM modulation format at 40 Gb/s over 150 km SMF is proposed. The 60 GHz millimeter-wave signal is generated by the optical heterodyne method. Coherent detection has been used at the receiver to down-convert millimeter-wave signal to IF band. Introduction of the OFDM modulation in RoF-based system realizes the benefits of higher order modulations (such as 4-QAM, 16-QAM, etc.) to ensure the good spectral efficiency and multi-gigabit access. The performance of the system is analyzed by Q-factor and BER by which it can be shown that the best results are obtained at the input power of 10 dBm. The simulation results clearly demonstrate the feasibility of this 4-QAM OFDM RoF system over 150 km fiber link.     

Estimation of the Maximum Annual Loads Modeling for Kingdom of Bahrain

The present paper proposes the impact of the air temperature on electricity demand as expected. It is clear that the annual maximum load is recorded versus the years starting by the year 2009 up to 2012. At present, the graph fitting technique is applied with some mathematical and computational tools based on the actual values of the years 2009 up to 2012 considering the lower values, the higher values and the average values of the annual maximum loads for Kingdom of Bahrain. For the three scenarios, the models are obtained by curve fitting technique. As well, the model of actual loads is obtained finally which has mostly the closest values obtained.     

Analytical solution for two-phase flow between two rotating cylinders filled with power law liquid and a micro layer of gas

This paper deals with the effects that a thin gas layer exerts on the hydrodynamic aspects of power law liquid in a radial Couette flow between two cylinders. Analytical solution is made to determine the velocity profile in the two-phase flow system occupied by the power law liquid and the micro layer of a gas. It is shown that the thin (micro) gas layer contributes in reducing torque to set the fluid in motion in most cases. However, by considering generalized power law liquids, this paper limits the credibility for the positive role of the gas layer on reducing the torque for lubrication. For instance, when n < 0.5 (n is the behavior index of the liquid), slight increment in the torque (about 6%) is reported. Finally, energy gradient method is used for stability analysis. It is shown that the stability nature may be changed based on behavior index of the liquid.     

PRP4 Promotes Skin Cancer by Inhibiting Production of Melanin,Blocking Influx of Extracellular Calcium,and Remodeling Cell Actin Cytoskeleton

Pre-mRNA processing factor 4B (PRP4) has previously been shown to induce epithelial-mesenchymal transition (EMT) and drug resistance in cancer cell lines. As melanin plays an important photoprotective role in the risk of sun-induced skin cancers, we have investigated whether PRP4 can induce drug resistance and regulate melanin biosynthesis in a murine melanoma (B16F10) cell line. Cells were incubated with a crucial melanogenesis stimulator, alpha-melanocyte-stimulating hormone, followed by transfection with PRP4. This resulted in the inhibition of the production of melanin via the downregulation of adenylyl cyclase-cyclic adenosine 3′,5′-monophosphate (AC)–(cAMP)–tyrosinase synthesis signaling pathway. Inhibition of melanin production by PRP4 leads to the promotion of carcinogenesis and induced drug resistance in B16F10 cells. Additionally, PRP4 overexpression upregulated the expression of β-arrestin 1 and desensitized the extracellular calcium-sensing receptor (CaSR), which in turn, inhibited the influx of extracellular Ca²⁺ ions. The decreased influx of Ca²⁺ was confirmed by a decreased expression level of calmodulin. We have demonstrated that transient receptor potential cation channel subfamily C member 1 was involved in the influx of CaSR-induced Ca²⁺ via a decreasing level of its expression. Furthermore, PRP4 overexpression downregulated the expression of AC, decreased the synthesis of cAMP, and modulated the actin cytoskeleton by inhibiting the expression of Ras homolog family member A (RhoA). Our investigation suggests that PRP4 inhibits the production of melanin in B16F10 cells, blocks the influx of Ca²⁺ through desensitization of CaSR, and modulates the actin cytoskeleton through downregulating the AC–cAMP pathway; taken together, these observations collectively lead to the promotion of skin carcinogenesis.     

Inline monitoring the effect of chemical inhibitor on the calcium carbonate precipitation and agglomeration

The formation of mineral scale particularly calcium carbonate is a problem for industries ranging from oil and gas to desalination plants. Various techniques have been studied to prevent the formation of scale. The use of chemical inhibitors to prevent calcium carbonate agglomeration is widely studied. The present study attempts to show that the inline monitoring technique is a useful tool for laboratory experimental investigation of agglomeration phenomenon. This method is successful in providing the induction time of starting agglomeration. It was shown that the presence of inhibitor delays the agglomeration and affects the deposition of calcium carbonate.In addition the method is found useful in determining the minimum inhibitor concentration and also to screen various types of inhibitors for the selection. The influence of an inhibitor is studied on scaling solution of various calcium ion concentrations. Finally, the result of inline technique was validated by comparing with the conventional one called offline technique. The SEM images reveal that the mechanism of inhibition might be the surface adsorption or distortion of inhibitor molecules on the growing calcium carbonate crystals.     

Development of novel potentiometric sensors for determination of tartrazine dye concentration in foodstuff products

Tartrazine dye Na₃TZ in foodstuff products was determined by a new modified carbon paste electrode, encoded sensor A, and a coated silver wire electrode, encoded sensor B, based on tartrazine TZ- cetryltrimethyl ammoniumbromide CTAB as a chemical modifier TZ-CTA. The electrodes exhibit the following characteristics listed respectively: a Nernstian slope of 17.9 ± 0.5 and 19.4 ± 0.2 mV/decade for tartrazine ion over a wide concentration range from 4.3 × 10⁻⁷ to 1.0 × 10⁻² and 1.1 × 10⁻⁷ to 1.0 × 10⁻² M. The lower detection limits: 3.2 × 10⁻⁷ and 5.5 × 10⁻⁸ M. Short response time (5–8 s) over the pH range 3.8–7.7 and 4.2–8.1. The proposed sensors display significantly high selectivity for TZ ion over a wide variety of sugars, some anions, common organic, inorganic compounds and additives. The developed electrodes were applied to the potentiometric determination of tartrazine ion in different kinds of foodstuffs: solid jelly (strawberry and custard) powder samples and soft drink (orange) samples with satisfactory results.